SIIG ID-DS0711-S1 Guia de Instalação descarregar pdf (Página 13)

8. A (Unconnceted) TCP Client... will be established.

Figure 14

(Unconnected) TCP Client...

9. Right click on the Virtualserial Port Console, click

Add Port, then follow steps 3-7 to add the second

serial port, if needed.

10. Close the Virtualserial Port Console and reopen it

to make sure the COM port is successfully added.

11. Go to the Self-Testing section below to make sure

the device is ready to use.

Self-Testing

The wiring architecture is similar to RS-232 Wiring on

page 17-18, and the serial device is replaced by the PC's

COM 1. The same PC also plays the roll of the Remote

Host. After completing the wiring and parameter setting,

refer to the following instructions to test the Serial over IP

Ethernet Device Server.

Hyper Terminal for TCP/IP WinSock

Hyper Terminal utility should be installed on your PC.

It can be found in your Windows installation CD. Initiate

Hyper Terminal from the Start Menu in Windows, see

Figure 15.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Sem comentários

SIIG ID-DS0711-S1 Guia de Instalação Página 13