SIIG UltraATA 133 PCI Guia de Instalação descarregar pdf (Página 5)

3. Install the hard disk drive to your computer. Attach

the end connector of the Ultra ATA cable to the

connector on the hard disk drive. Make certain that

pin 1 on the cable (indicated by the stripe) matches

pin 1 on the hard disk drive’s connector. The same

procedure applies when making connection to IDE2.

Note: The ribbon cable has two connectors. If you

have one hard disk drive, connect it to the end

connector of cable. If you have a second hard disk

drive, connect it to the middle connector of cable.

Figure 3. Connecting Internal Drives

4. Reconnect the system power and other peripherals

to your computer.

RAID Arrays

RAID Arrays are setup in the UltraATA 133 PCI RAID's

BIOS. Find your RAID set and follow the steps in the

order in which they appear.

RAID 0 (striping) .............................................. page 6

RAID 1 (mirroring)........................................page 7-9

RAID 0+1 (mirror+striping) ....................page 10-11

Deleting RAID Arrays ................................... page 12

Resolving Conflicts........................................ page 12

IDE1

IDE2

Internal

Drive 1

UltraATA 133 PCI RAID

Drive 1 Drive 2

Internal

Drive 2

(If Any)

End Connector

Middle Connector

1 2 3 4 5 6 7 8 9 10 ... 31 32

Sem comentários

SIIG UltraATA 133 PCI Guia de Instalação Página 5