SIIG UltraATA 133 PCI Guia de Instalação descarregar pdf (Página 11)

4. Press A to Auto configure.

5. Press Y to accept the configuration.

6. Press ESC to reboot.

7. Continue with Fdisk and Format steps as if you

were installing a conventional hard drive.

Rebuilding a Failed RAID 0+1 Set

The steps below will guide you in rebuilding a failed

Mirrored-Stripe set.

1. Replace the failed drive with one of identical size or

of larger capacity.

Note: It is recommended to replace the bad drive

with an identical drive, or with a drive of the same

make. In all cases, the replacement drive must be of

equal or larger capacity than the bad drive.

2. Start the computer and during boot press F3, when

prompted, to enter the RAID BIOS.

3. Press F3 to assign a Spare drive.

4. Press the number corresponding to the new drive.

5. When asked Are You Sure? Press Y to accept.

6. Press ESC to exit the RAID BIOS and reboot the

computer.

Note: Ignore the error message displayed by the

RAID BIOS and continue booting. The mirror will

rebuild automatically.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Sem comentários

SIIG UltraATA 133 PCI Guia de Instalação Página 11