SIIG Serial ATA 4-Channel RAID Guia de Instalação descarregar pdf (Página 19)

For An Existing Installation

1. Setup the RAID array prior to driver installation and

boot up to Windows.

2. When Found New Hardware Wizard appears, click

Next to continue.

3. Select Search for a suitable driver for my device

(recommended), then click Next.

4. Insert the driver CD, check CD-ROM drives, uncheck

the other check boxes, then click Next.

5. If the Digital Signature Not Found message appears,

click Yes. Our driver has been thoroughly tested for

stability and compatibility.

Note: If prompted for Windows 2000 CD-ROM,

insert the CD into your CD-ROM drive and click

OK. Type in D:\I386 (change D: to match your CD-

ROM drive letter), click OK, then Finish.

6. Click Next, then Finish. Remove the driver CD, then

restart Windows to complete the installation.

When Windows resumes, go to SATARaid on page 22

and install the RAID monitoring utility.

Windows XP

A new installation of Windows XP requires a floppy disk

for the driver installation. To make this floppy disk, copy

the contents of the Floppy folder, found on the driver CD,

onto a blank floppy disk then follow the directions below.

For A New Installation

Important: During Windows XP installation you will be

asked to restart several times. If during any restart the

RAID BIOS reports an incomplete RAID set, disregard

the message, continue with the installation, and let the

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 33 34

Sem comentários

SIIG Serial ATA 4-Channel RAID Guia de Instalação Página 19