SIIG Serial ATA 4-Channel RAID Guia de Instalação descarregar pdf (Página 16)

For A New Installation

Important: During NT installation you will be asked to

restart several times. If during any restart the RAID BIOS

reports an incomplete Mirror set, disregard the message,

continue with the installation, and let the Mirror rebuild

on its own. This should happen only once and it's done

automatically. Please do not interfere this process.

Setup the RAID array prior to NT installation.

1. Setup the RAID array prior to NT installation.

2. Follow Microsoft's NT installation procedure.

3. When booting from Microsoft Windows NT 4.0 CD,

the following screens will appear.

4. Screen 1, Setup is inspecting your computer's

hardware configuration, press F6 key to specify

and add the driver.

5. Screen 2, Windows NT Setup, Setup is loading

files, keep pressing F6 key to add the driver.

6. Screen 3, if screen 3 does not appear for options to

Specify Additional Device then shut off system

and repeat steps 4-5 otherwise continue to step 7.

7. Insert the driver diskette and press S.

8. Screen 4, Windows NT Setup, highlight Other and

hit Enter.

9. Screen 5, Windows NT Setup, make sure driver

diskette is in floppy drive and press Enter.

10. Screen 6, Windows NT Setup, highlight Silicon

Image Sil 3x14 SATARaid Controller for Windows

NT 4.0 and 2000 and hit Enter to load driver.

11. Screen 7, Windows NT Setup, the RAID driver,

Silicon Image Sil 3x14 SATARaid Controller for

Windows NT 4.0 and 2000 should be listed. Press

Enter.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 33 34

Sem comentários

SIIG Serial ATA 4-Channel RAID Guia de Instalação Página 16