SIIG Serial ATA PCI Guia de Instalação descarregar pdf (Página 10)

For Existing XP (64-bit) / 2003 (64-bit) Installation

1. Install the board and boot up Windows.

2. At the Found New Hardware Wizard, select No, not

at this time, then click Next.

3. Insert the driver CD, select Install the software

automatically (Recommended), and click Next.

4. Click Finish and restart Windows to complete the

installation.

Windows 2000

For New Windows 2000 Installation

A new installation of Windows 2000 requires a floppy

disk for the driver installation. To make this floppy disk,

copy the contents of the Floppy folder, found on the

driver CD, onto a blank floppy disk then follow the

directions below.

1. Install the board and follow Microsoft procedures

to install Windows 2000 accordingly.

2. Restart your system when prompted during

Windows' installation.

3. At the Windows 2000 Setup screen, press F6 to

install the driver.

4. Insert the driver diskette. Press S, then press Enter.

5. Select Silicon Image SiI... Controller and press

Enter.

6. Press Enter to continue and follow on-screen

instructions to complete the installation.

For Existing Windows 2000 Installation

1. Install the board and boot up Windows 2000.

2. At the Found New Hardware Wizard, click Next.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Sem comentários

SIIG Serial ATA PCI Guia de Instalação Página 10