SIIG SC-SAE311-S1 Guia de Instalação descarregar pdf (Página 7)

Single Drive Setup

Setting up your hard drive to operate as a single drive

may destroy all existing data on your hard drive, therefore,

back up any data on your hard drive before connecting it

to the raid controller or use a blank or new hard drive.

1. As the BIOS boots press Ctrl+S or F4 when prompted

to enter the RAID BIOS.

2. At the next screen select Create RAID Set, then

press Enter.

3. Select Concatenation, then press Enter.

4. Select 1, then press Enter.

5. Select a hard disk drive, then press Enter.

6. When asked Are You Sure (Y/N)?, press Y to accept.

Note: In the RAID BIOS screen, under Logical Drive,

SiI Concatenation and the size of the logical drive

will appear.

7. Press Ctrl+E to exit the BIOS.

8. When asked Are you sure to exit (Y/N)?, press Y to

exit and reboot.

Note: The hard disk will show up as Contiguous in

the SATARAID5 GUI.

JBOD Drive Setup

This RAID Array combines the full capacity of two hard

drives to form one logical drive. Since this configuration

will destroy all existing data on your hard drives, use

blank or new hard drives or back up your existing data

before connecting to the raid controller.

1. As the BIOS boots press Ctrl+S or F4 when prompted

to enter the RAID BIOS.

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Sem comentários

SIIG SC-SAE311-S1 Guia de Instalação Página 7