SIIG Serial ATA PCI RAID Manual do Utilizador descarregar pdf (Página 21)

User's Manual

2-10

Press F1 to delete RAID set

Press F2 to create RAID set

Press F3 to create spare drive

Press F4 to resolve conflicts

Press <ESC> to exit RAID configuration utility

2-3 Creating RAID Arrays

The UltraATA 100 RAID BIOS will list the hard drives attached to

the controller. The physical drives are labeled 0, 1, 2, 3. Use this

numbering sequence when defining the drives in your RAID

Arrays.CMD Medley provides three RAID set types, Stripe (RAID

0), Mirror (RAID 1), and Mirror-Stripe (RAID 0+1).

2-3.1 RAID 0 (striping)

This RAID array to be used on New/Blank hard drives, do

not stripe an existing Windows installation.

1. As the BIOS boots press F3 when prompted to enter

the UltraATA 100 RAID BIOS utility.

2. At the next screen press F2 to form a RAID set.

3. Press F1 to create RAID 0.

4. Choose the chunk size to be used in the RAID set

(64 is recommended).

5. Choose the number of drives in your stripe set.

6. Assign the drives to be used. For optimal

performance, alternate drives from seperate IDE

channels.

7. After all drives are entered, press Y to create the

RAID set.

8. Press ESC to exit the UltraATA RAID BIOS and

boot your computer.

9. Continue with Fdisk and Format steps as if you are

installing a conventional hard drive.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 53 54

Sem comentários

SIIG Serial ATA PCI RAID Manual do Utilizador Página 21