SIIG Serial ATA PCI Guia de Instalação descarregar pdf (Página 17)

3. Restart the computer when prompted by the

installation.

4. At the Windows 2000 Setup screen, press F6.

5. When prompted press S to specify the location of

the driver.

6. Insert the driver diskette, then press Enter.

7. Select Silicon Image SiI 3x12 SATARaid Controller

for Windows NT 4.0 and 2000, then press Enter.

8. Press Enter to finish driver installation, then follow

the on-screen instructions to complete the

installation.

When Windows installation completes, go to Installing

SATARaid GUI on page 20 and install the RAID utility.

For an Existing Windows 2000 Installation

1. Install the board and boot up to Windows.

2. At the Found New Hardware Wizard, click Next.

3. Select Search for a suitable driver for my device

(recommended), then click Next.

4. Insert the driver CD, check CD-ROM drives, uncheck

the other check boxes, click Next, click Next again.

5. Click Finish. Remove the driver CD, shutdown

Windows, and setup your RAID array.

When Windows resumes, go to Installing SATARaid

GUI on page 20 and install the RAID utility.

To Verify Windows 2000 Installation

1. Right click My Computer, click Manage, click

Device Manager.

2. Double click SCSI and RAID controllers, Silicon

Image SiI 3512 SATARaid Controller should be

displayed.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

Sem comentários

SIIG Serial ATA PCI Guia de Instalação Página 17