SIIG SC-UNS012 Guia de Instalação descarregar pdf (Página 5)

4. Windows restarts. At the Add New Hardware Wizard

window, click Next.

5. Choose Search for the best driver... and click Next.

6. Uncheck all boxes and click Next.

7. Click Next and Finish.

8. At the Add New Hardware Wizard, click Next.

9. Choose Search for the best driver... and click Next.

10. Uncheck all boxes and click Next.

11. Click Next and Next again. If prompted, insert your

Windows 98SE CD-ROM and click OK. Click Finish.

12. Repeat steps 8-11 two more times.

13. At the Add New Hardware Wizard, click Next.

14. Choose Search for the best driver..., and click Next.

15. Insert the Serial ATA driver diskette. Check Floppy disk

drives, uncheck the other boxes, then click Next.

16. Click Next and Finish.

17. Remove the driver diskette and restart the computer to

complete driver installation.

Windows ME Driver Installation

1. Boot up Windows. At the Add New Hardware Wizard

window, click Cancel.

Note: Click Cancel 4 times if a hard disk drive is attached.

2. Insert the USB 2.0 driver diskette. Click Start, Run, type in

A:\setup206.exe, then click OK.

3. Choose Yes, I want to restart my computer now, then click

Close. Remove the driver diskette.

4. Windows restarts. The Add New Hardware Wizard detects

PCI standard PCI to PCI bridge, choose Automatic Search

for a better driver, click Next, then click Finish.

5. When the Add New Hardware Wizard detects a 1394 Host

Controller, choose Automatic Search for a better driver, click

Next, then click Finish.

1 2 3 4 5 6 7 8 9 10

Sem comentários

SIIG SC-UNS012 Guia de Instalação Página 5