SIIG 2-Port FireWire ExpressCard Guia de Instalação descarregar pdf (Página 4)

Connecting a DV Camcorder

Before setting up the digital video camcorder, verify the

FireWire 2-Port ExressCard driver has been successfully

installed in your system, then follow the procedures

below.

1. Boot up your system.

2. Connect the 4-pin connector of the provided

FireWire 400 (1394a) DV cable to your camcorder.

3. Connect the 6-pin connector to the FireWire 400

(1394a) port.

4. Power on the camcorder. The camcorder should

now appear in Device Manager.

Inserting / Removing FireWire Devices

When inserting/removing your FireWire device, hold the

ExpressCard and make sure it does not move around

inside the slot, otherwise, the ExpressCard may loose

connection or could be ejected from the slot.

Important: Before removing a FireWire device, use

Windows Unplug or Eject Hardware/Safely Remove

Hardware feature, located in the taskbar, to Stop it.

Removing the ExpressCard

Before removing the FireWire 2-Port ExpressCard, use

Windows Unplug or Eject Hardware/Safely Remove

Hardware feature, located in the taskbar, to Stop it.

1 2 3 4 5 6 7 8

Sem comentários

SIIG 2-Port FireWire ExpressCard Guia de Instalação Página 4